LED太陽能路燈調試系統工作是否正常;松開控制器上太陽板連接線,燈亮;同時接上太陽板連接線,燈熄;再仔細觀察控制器上各指示燈的變化;一切屬于正常,方可封好控制箱。
1、蓄電池置于防水箱內時須輕拿輕放,防止砸壞防水箱;
2、輸出線連接在蓄電池后在任何情況下禁止短接,避免損壞蓄電池;
3、蓄電池的輸出線與電線桿內的控制器相聯時必須通過PVC穿線管;
4、上述完成后,檢查控制器端的接線,防止短路。正常后關好控制箱的門。
1、太陽能電池板的輸出正負極在連接到控制器前須采取措施避免短接;
2、太陽電池組件與支架連接時要牢固可靠;
3、組件的輸出線應避免裸露,并用扎帶扎牢;
4、電池組件的朝向要朝正南,以指南針指向為準。
Whether the LED solar street lamp debugging system works normally; Loosen the connection line of the sun board on the controller, the light will be on; At the same time, connect to the sun plate, the light is off; Carefully observe the changes of the indicators on the controller; Seal the control box until everything is normal.
1. When the battery is placed in the waterproof box, it must be handled with care to prevent damage to the waterproof water tank;
2. After the output line is connected to the battery, short connection is forbidden under any circumstances to avoid damage to the battery;
3, the output line of the battery and the controller in the pole must be connected through PVC threading pipe;
4. After the above, check the wiring of the controller to prevent short circuit. Close the door of the control box after normal.
1, solar panel output positive and negative poles before connecting to the controller must take measures to avoid short connection;
2. The solar cell module should be firmly and reliably connected with the bracket;
3, the output line of the component should avoid bare, and tie it securely;
4. The orientation of the battery components should be due south, as indicated by the compass.